As some of you may recall I set about modifying my MSFFB2 and Saitek X55 to see if I could combine them. Frankenstein time for sure! Today I finally got the missing pieces I needed, contact pads for the spring loaded contacts in the handle, that finally enabled me to complete connectivity. It works! Showing illuminated joystick. Red wine, the ultimate creative fuel! The other thing is the X55 stick paired with the MSFFB2 base, to the left (below the vino) you can see the Dsub 25 connector that pairs the handle back to its now divorced base. Said divorced base, currently not using the X or Y axis, but all buttons on the stick fully functional, FFB is pretty good, handle holds center no problem as the weight distribution is spot on. Next up is implementing trim using the X and Y axis on the X 55 base, and integrating the MSFFB2 buttons and hat (the interconnect cable has 15 spare connections so no issue doing this at all). Once the above is done I will then work on the collective mod I dreamt of, should make DCS rotary flying more intuitive with natural controls and FFB. Have 17 days vacation commencing next Friday, so hoping for more accelerated progress. [emoji4][emoji4][emoji41] Sent from my iPhone using Tapatalk