Something different but still modeling (kinda)

[B16Enk]

Treated myself to a 3D printer a while ago, was going to make an extension for my X55, then it occurred to me I could be a little more adventurous!

 

So I made this:

Underside view:

 

WTF I hear you ask!

 

It is an adaptor to couple the X55 joystick handle to a MSFFB2, non destructive to both sticks, and when I have done some soldering fully working with all buttons and hats.

 

Next up is a clip on adapter to turn the X55 base into a trim control for all 3 axis and a button bay for the displaced MSFFB2 buttons.

 

Ultimately I am looking to also create a throttle/pitch mod for the X55 base too, to add a little more immersion to helicopter flying [emoji4]

 

Have enjoyed being an engineer again, and using 3D CAD to produce the design!

 

 

 

Sent from my iPhone using Tapatalk

[Snacko]

Very cool Roger!

Which printer did you get? My buddy started a company called Maker Mark in Cleveland.

Sent from my Moto Z Play using Tapatalk

[B16Enk]

I've heard of Maker Mark! I got a Monoprice Maker Select, an iPrusa clone. It holds 0.1 mm fine and is a good starter printer.


Sent from my iPhone using Tapatalk

[Jabo]

That is properly cool Rog - Could be a nice little earner there if you were so inclined.