Jump to content

Leaderboard

Popular Content

Showing content with the highest reputation on 08/22/2017 in all areas

  1. Wow. July I posted this! I guess I should post an update: Base bit is being printed right now, will take over 20 hours to print The grey is a test fit for throttle grip, it works fine, will print final piece with textured (knurled) grip. Most of the black pieces are 15% carbon fibre, gives a nice matt yet metallic finish. Base is pure PLA and is high gloss black, the top of the base (with switches) will probably be the same matt finish carbon fire, Axis are hall sender for throttle and pitch, buttons are momentary 2 way toggles (like the X55) and this is all powered by a Bodnar board. Tension adjustment on the pitch axis, works very smoothly. Need to wire it all up when the base is printed, am creating bespoke PCBs for the Bodnar to switch interface, with diodes to do the matrix thing and give me 32 switches total. Only one pot so far, with a red knob.. steady Painless!
    3 points
  2. 2 points
×
×
  • Create New...